Visitor No. 1862812 from US.  
Kenplas Industry Ltd.
　
Kenplas Forum ==> Others ==> Black Specks in caps
[Previous Topic] [Next Topic]
1
If that is the case, please contact Husky, we're not sure about their mold design.

Another guess: material mixed with recycled material?

Fine
1
 Poor
12/20/2007 8:42:15 PM By Kenplas
pls let me know more details. we used the purging material from ultra purge P-0 Grade which is too helpless. pls advise permanent solution to remove black specs.

Fine
Poor
12/20/2007 7:31:10 PM By sundharlal
Most probably there are some dead corners inside the hot manifold where material stays there and heated for long time.

Fine
Poor
12/20/2007 11:23:31 AM By Kenplas
we are manufacturing of Caps from HDPE with mixing of LDPE through Husky Hot runner mould. There's a Black pints in so many products which is unsolved problem. We try to adjusting tempereratures and processing parameters also which is useless. Anybody can advise pls.

Fine
4
 Poor
12/19/2007 8:23:38 PM By sundharlal
1
 
 

Post A Reply

Name:

Email:

Message:

(Max. 2KB)


Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.
[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2010 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.