Visitor No. 1862812 from US.  
Kenplas Industry Ltd.
　
Kenplas Forum ==> Trouble Shooting --PET Bottle Stretch Blow Molding
1 2
TopicRepliesViewsLast Update
PET bottel stretch blow moulding 1 9 9/7/2010 4:29:49 PM
Regarding New PET bottle unit 2 193 8/12/2010 2:30:52 AM
strees crack 2 311 7/27/2010 1:29:58 PM
Pressures 5 1114 6/21/2010 8:36:40 PM
preform bent during heating in pet blowmoulding machine 10 751 4/20/2010 9:25:46 PM
Veins (flower pattern) on bottle 2 753 2/17/2010 5:42:12 PM
Bottle surface like orange peel / thickness change wave near the support ring (skirt) of the bottle 1 186 11/17/2009 5:49:10 AM
Pearlescense 3 1260 11/1/2009 9:59:24 PM
Bottle get stuck on the bottom of the mould 1 233 7/13/2009 1:49:30 AM
Bottle Neck Deforms 5 1070 7/7/2009 2:47:28 PM
Sticky PET bottles 2 832 3/26/2009 7:43:31 PM
leaking base 2 584 12/11/2008 12:34:04 AM
Bottle Wall Thickness not Uniform (Radial) 2 1290 11/19/2008 6:53:40 AM
Different moleculair structure fresh/old PET? 1 647 10/28/2008 4:51:13 PM
Problem on bottle bottom 1 580 9/11/2008 12:16:55 AM
bottle bottom crack 2 597 8/23/2008 12:53:43 PM
Preform Bottom Bursts while Stretching/Blowing 4 1656 7/20/2008 7:08:52 AM
Bottle is not fully shaped 3 1506 3/9/2007 1:18:24 PM
Bottle bottom is not fully shaped 2 1288 1/17/2007 11:16:49 PM
Water Taste Changed after some time 5 1433 12/27/2006 1:05:53 PM
1 2
 

Start A New Topic

Name:

Email:
Topic Name:

Message:

(Max.  2KB)


Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.
[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2010 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.